Cookies enable us to provide the best experience possible and help us understand how visitors use our website. By browsing World Pumps, you agree to our use of cookies.
David Amory, global head of marketing for AESSEAL, explains how his company helped a Danish dairy save water when flushing seal faces.
How a compressor and vacuum system upgrade resulted in savings of around £38,000 per year in energy costs and reduced carbon dioxide emissions.
How to improve total cost of ownership and reduce whole life costs for pump technology in light of the wider move towards the circular economy.
Kobold’s electromagnetic flowmeter duo the MIM and MIS, aim to bring precise dosing to the smallest quantities.
How John Crane's dynamic lift up-stream pumping seal face technology assisted a US manufacturer and blending facility of liquid and dry sweetener products.
WEFTEC is the largest wastewater trade show in the US. In this show review, Michelle Segrest gives her impressions from the showroom floor.
Bearing isolators have an unlimited life expectancy and do not fail under normal circumstances and are rarely the cause of equipment downtime.
A fan series with a hybrid ceramic bearing helped keep maintenance costs low and a service life long.
Full vibration analysis of a new high-speed centrifugal pump resulted in major savings that could be passed on to the customer.
How the use of vibration monitoring solutions keeps production lines running smoothly.
John Crane turns round a power plant’s seal installments, as well as in-house repair and stocking regimes.
Choosing a rubber lining for mining or quarrying is complex
During a mechanical seal replacement of a major gas plant, the pump was found to be operating below Minimum Continuous Stable Flow.
Long-term planning is beneficial; project managers and policy-makers need to think more strategically about how to operate and maintain these systems.
Contact seals tend to either wear at the point of contact or groove the shaft.
This article explores the possibility of designing a hydraulic element which is fit for Industry 4.0.
Manufacturers need to find ways to adapt to current challenges, including investing in next-generation technologies.
Melaka is a small state on the Malay Peninsula. In 2008, the authorities decided to upgrade its water infrastructure to reduce Non-Revenue Water loss. The
An upgrade of the water treatment and water supply system in Samara in south-east Russia, not only replaced outdated control equipment but also saw the imp
The article 'The monitoring system of an actual technical condition for pumping units with frequency analysis' has been published in Elsevier journal Proce
Jeson Pitt works with the marketing department of D & F Liquidators, Hayward, CA, US.
The top five things that cause inverter failure
The AC power variant of the PAX1 low voltage actuators is designed for use in remote explosion-proof locations.
The part was manufactured, inspected and shipped within an hour.
Exhibition & conference for the painting and coatings industry.
Exhibition for smart automation and robotics.